Mounting your TV on the wall is one of the cleanest, fastest upgrades you can make to a Cypress, Tomball, or Hockley living room — but doing it right means more than just hanging a screen. Here is what you actually need to know in 2026, including viewing angles, mount types, cable concealment, and what it costs to have us handle it for you.
Why mount a TV on the wall?
It looks better. A wall-mounted TV gives a clean, intentional look — no console, no visible cables, no glare from a nearby table lamp. Modern flat mounts hold a 65″ TV less than 1.5 inches off the wall, so it almost looks built-in.
It frees up floor space. Especially helpful in newer Bridgeland, Towne Lake, and Coles Crossing homes that lean toward open-concept living. No console means more room for a couch, a play area, or just easier vacuuming.
It is safer with kids and pets. A TV on a stand is one good bump away from a broken screen. A properly mounted TV is locked into a wall stud and is not going anywhere.
It is the right viewing height. Eye-level for the seated viewer is the sweet spot. Sitting on a couch and staring up at a TV mounted over a fireplace can cause real neck strain over a 90-minute movie. We measure for the right height before we drill a single hole.
Pick the right type of mount
Not every wall, room, or TV calls for the same mount. The four most common types we install in Cypress homes:
-
Flat (fixed) mounts — sit close to the wall, no movement. Best for one-seat-position rooms with no glare problems.
-
Tilting mounts — tilt 12 to 20 degrees down. Best when the TV has to go higher than eye level (over a fireplace, in a bedroom).
-
Full-motion mounts — extend, swivel, and tilt. Best for open-concept rooms where the TV has to be visible from multiple seating areas.
-
Outdoor / weather-rated mounts — for covered patios, outdoor kitchens, and screened porches. Important in Cypress, where Texas humidity and direct sun will eat a regular indoor mount in two summers. We pair these with a weather-rated TV (Samsung Terrace, SunBriteTV, etc.) so the whole setup survives.
Cable concealment — the make-or-break detail
The number-one mistake on DIY wall mounts: a clean TV with a tangle of cables hanging visibly underneath. There are three ways to fix that:
-
In-wall cable kits ($30 to $80 in materials, plus our labor) — drill two recessed plates, fish the HDMI and power through the wall cavity. Code-compliant when done with the right components. Cleanest result.
-
Surface raceway — paintable plastic channel that hides cables on the wall surface. Best when in-wall is not an option (brick, concrete, fire-blocking).
-
Built-in recessed outlet behind the TV — the gold standard for new construction or remodels. Power and low-voltage in one tidy box behind the screen.
For Texas-built homes, watch out: the National Electric Code does not allow standard high-voltage power cords run inside walls. We install a power relocation kit when an outlet does not already exist behind the TV, which keeps you up to code and protects your insurance if anything ever goes wrong.
How long does it take?
An entry-level on-wall installation runs 60 to 90 minutes per device. Add 30 to 60 minutes if cable concealment is involved, plus extra time if we are mounting over masonry (fireplace surrounds, brick exterior walls).
What it costs in Cypress
Our menu pricing for the most common scenarios:
-
On-Wall TV Installation — $99 flat for a standard wall mount install on drywall.
-
Fireplace TV Installation — $199 for a tilting mount over a fireplace, including heat clearance check.
-
Table Top TV Installation — $89 if you would rather we just place and configure it on a console.
Cable concealment is quoted on-site once we see the wall and routing options.
Common mistakes we see (and fix)
-
Wrong screws. Mount manufacturers ship multiple screw sizes. Using one too long can crack the back of an LED panel. Using one too short can let the TV fall.
-
No stud check. Drywall anchors alone are not rated for a 75″ TV. We always anchor to studs (or to a properly installed mounting board if studs are not where we need them).
-
Wrong mount for the room. Buying a flat mount when the seating angle calls for full-motion. We measure first and then recommend.
-
Ignoring fireplace heat. Above a wood-burning fireplace, the temperature behind a TV can climb above the manufacturer’s rated maximum. We measure and pull the TV further out (or recommend not mounting there at all).
Ready to get it done in Cypress?
We serve Cypress, Tomball, Hockley, Bridgeland, Towne Lake, Coles Crossing, Jersey Village, and the surrounding northwest Houston area. See all of our TV installation services, or book your install online and pick a date that works for you. Questions? Call us at (281) 742-2050.